7 of 8
300-5577-00 rev. J • 10/16
R AT I N G S
Electrical Rating
Voltage rating: 120Vac, 60 Hz. When desk is moving with rated load: 400W. When desk is not moving: less than
100mW.
Temperature Ratings
Ambient temperature: 41 degrees F to 140 degrees F. Storage temperature: -4 degrees F to 158 degrees F.
Acclimate table to ambient temperature before use.
Load Rating
Elevate II has a weight capacity of 150 lbs of distributed load.
Duty Cycle
Elevate II has a 10% duty cycle. This provides 6 minutes of movement per hour or two minutes of continuous
use at full load. Once the table reaches its duty cycle, the table shuts down to cool; this usually takes about 20
minutes. Duty cycle is reduced when the load exceeds approved weight limit or temperature is outside the stated
range.
S A F E T Y C H E C K
Plug in the table and home the legs. To home the legs, move the table to its lowest position, release the DOWN
button, then press and hold the DOWN button for 5 seconds. The table will bump a few times, then rest.
Raise the table to its highest position. Watch all the cords and cables as the table moves to verify that cords aren't
wrapped around anything and that nothing interferes with the movement of the table.
Every time you add equipment onto the table, route cords into the cable tray. Carefully move the table through
its entire range of motion to be sure that your power and data cables are long enough. Check the area around
your table for obstructions below, beside, and above the table to be sure there are no collisions.
Verify that the load is distributed evenly across the table.
M o v i n g t h e t a b l e
Keep your equipment safe: remove equipment from the table before you move it.
Before moving the table, lower the table all the way down.
To move the table, lift the surface enough to get the front feet off the ground, and roll it into place.
Lift (don't roll) the table over thresholds, transitions, or bumps.
