4 of 8
300-5577-00 rev. J • 10/16
3/4" Button Hd PB Screw
325-5575-00
A
B
M6-10 Button-head Screw
325-5503-00
C
D
M6x14 Flat Hd Screw
325-5435-00
3/4" Button Hd PB Screw
325-5575-00
E
S T E P 1 - AT TAC H G U S S E T S TO TO P
Lay the worksurface upside down on a cushioned, non-marring surface.
Locate the front edge of the table. On Plus tables, the front of the table
has a sloping waterfall edge. On the Basic tables, the back edge of the
table has the seam where the edgebanding meets.
Align the Leg Gussets with the holes on the top so the upright fl ange faces
the outside of the table and the tapering end points to the front of the
table.
Attach each gusset to the worksurface with six 3/4" Button Hd PB Screws
(325-5575-00) using the Anthro driver.
S T E P 2 - I N S TA L L L E G S
Align one Leg with one Leg Gusset so the cord feeds out of the
Leg toward the center of the table. The Leg will rest on top of the
Gusset's button-head screws, so it may feel a little wobbly. [A]
Slide a Leg Housing over the Leg and down until it covers the Leg
Motor and the six screw holes on the housing line up with the six
pre-drilled holes on the shelf. [B]
Move to the front of the table and attach the front of the Housing
to the Leg with two M6-10MM Button Hd Screws (325-5503-00)
using the Anthro driver. Tilt the leg slightly to align the holes. [C]
Loosely attach the Housing to the shelf with six 3/4" Button Hd PB
Screws (325-5575-00). [D]
Attach the side of the Leg to the Leg Gusset with two M6-14 Flat-
head Screws (325-5435-00). [E]
Repeat for the other Leg and Housing.
