Desk with memory panel (with LCD readout)
Normal Operation:
To run the table up or down, press the “Parallel Up” or “Parallel Down” button, and keep it
pressed until the table reaches your desired height. The display will count up or down while
running, and after it stops will continuously show the current height of the table.
Store a memory position:
1. Run the desk to the desired height.
2.
Press the “Store” button and the display will flash “S” for 2 seconds.
3. Within the 2
seconds press “Memory 1, 2 or 3. The position is now stored.
4.
To abort the sequence press the “up” or “Down” whilst the “S” is flashing, or wait 2
seconds until the display automatically returns to show the height of the table.
Recalling a memory position:
1. Press and hold the "memory 1" button until desk reaches stored position and stops.
2. Repeat previous step for memory position 2 and 3.
3. Memory positions can be bypassed by pressing the "parallel up" or "parallel down"
buttons.
Adjusting the display to show the correct height:
Adjusting initial height
It may be necessary to adjust the displayed height due to different thicknesses of desktops. As
a standard it will show 68cm as the default height of the desk.
1. Press /\ and \/ keys at the same time and keep them pressed for 5 seconds. The display
will show three minuses (---) and then the display will revert to showing the height.
2. The height can then be adjusted by either /\ or \/ until the desired height has been
reached.
3. The system will return to normal operation (and give a short blink) after 5 seconds of
inactivity on the keys.
Desk with Bluetooth, memory and reminders (DPG1C)
See following link to download information on setting up and details on this desk panel: -
