To Change Parameters
To enter the System’s data bank, monitor operations and verify the vital functions concerning
your unit, use the following step-by-step instructions. Note: Each timer manufactured after
1995 displays the current software version on power up. These instructions are for level 23
and above of the Intellitan Plus timer.
Enter Password Clearance
1.
Press (at the same time) then release
s
and
t
buttons; the display will change from
00:00 to
0000
.
If you cannot get the display to change to
0000,
assure that you have
disconnected the network cable(s) from the timer. If power to the tanning unit is not
cycled on/off after disconnecting the network cable, you must wait for thirty seconds for
the timer to award access to the above mentioned buttons.
2.
Press the Reset button once so that
0000 begin to flash.
3.
Use the
s
button to enter the appropriate password to perform the desired function.
Password
0010 (ten) must be entered to view parameters, and
0102 (one hundred and
two) to edit parameters. After entering the password press the
Reset
button. The
display will stop flashing and
0001(level one) or 0002
(level two) will appear in the
display.
4.
Press the Start/Stop button to reach the desired parameter. If you go past a parameter
press the
st
button to exit parameter mode and restart from step 1. Each time the
Start/Stop is pressed the timer will display
PXX (XX represents numbers) representing
the parameter reached and then the display will change showing the value of the
parameter.
5.
If you are using the second level password, press the Reset
button to edit the parameter
(once the Reset button is pressed the display will begin to flash). Use either the
t
or
s
button to set the appropriate value for the parameter, then press
to exit the parameter.
6.
Press the Start/Stop
to advance to the next parameter. You may
st
press buttons
simultaneously to exit the edit parameter mode.