Option 1: For table tops with AdapTABLE preinstalled nuts:
Align the 6 screw holes (2 on each Side Bracket and 1 on each End
Frame) to the preinstalled nuts on AdapTABLE supplied table tops.
Insert and fasten using 6 screws from Pack C to fix the frame to the
table top.
Option 2: For table tops without preinstalled nuts:
Slide the Lift Columns out and leave approximately 3
–
4cm of space
at each end. Center the frame assembly to the table top. Insert and
fasten using 6 wood screws from Pack D to fix the frame to the
table top.
Check and make sure that the supplied wood screws in Pack
D are not too long for the table top. Wood screws which are
too long can puncture and damage the work surface. If the
wood screws are too long, purchase shorter wood
screws which fits your table top.
Maximum width of the frame is 180cm.
Attach the Control Box (Part 6) by sliding it into the bracket welded
to the End Frame (Part 1).
Align the handset (Part 7) flushed to the front edge of the table top
(tapped holes are available on both sides of AdapTABLE supplied
table tops). Insert and fasten using 2 wood screws from Pack D.
Do not overtighten the screws. Overtightening could cause
damage to the components.
STEP 5 - CONTINUED
