Installation
1
NB
It is strongly recommended that 2 qualifi ed
persons complete the installation of the product.
Failure to do so could result in serious injury and
possible damage to the fl at panel.
Raise the fl at panel with the mounting brackets
secured to the fl at panel and insert the top and
bottom hooks from each bracket to the rods from
the wall plates.
NB
Do not over tighten the M6 screws to the rods.
Lateral Shift Adjustment
Locate the two (2) mounting holes that are on the
bottom of each mounting bracket arm.
Insert and tighten two (2) M6 x 30mm lateral shift
locking screws.
Make any lateral shift adjustments at this time. Once
the desired position has been determined, use a
Phillips tip screwdriver and tighten the two lateral
shift locking screws.
NB
Although not depicted in the illustrations shown,
the width of this wall mount will encompass two
wall studs.
Safety Knurl Knob Installation
Tilt the fl at panel and secure two (2) M6 x 12mm
safety knobs to each of the mounting brackets.
Removing the Display from the Wall
Perform the following steps to remove the fl at panel
from the wall mount.
Extend the display to its maximum tilt range.
Remove the two M6 x 12mm safety knurl knobs.
Push the fl at panel back to its fl at position.
Loosen or remove the two (2) M6 x 30 lateral shift
screws.
Lift the unit off the wall plate.
Securing the Plasma to the Wall Mount
1
2
3
1
1
2
3
4
5
Содержание EMCTM-MS2
Страница 1: ...EMCTM MS2 Flat Panel Display Mount...
