erc MICRO BOOMERANG RC Ready, Руководство пользователя

Страница: 5 / 12

Binding the Model
RTF versions are shipped ready to fly. If you find the controls are not responding to the transmit-
ter, it may be necessary to bind the radio system.
RC Ready version, you will need to bind the model to your existing eRC transmitter before the
model will respond to the transmitter. (This model will only bind to an eRC transmitter)
elevator Control
Moving the left stick to the top of the transmitter will
make the elevator move down.
In the air, this will cause the plane to dive.
Moving the stick toward the bottom of the transmitter
will make the elevator go up.
In flight this will make the model climb.
rudder Control
Moving the right stick to the right will make the rudder
go right.
In flight this will make the model turn to the right.
Moving the stick to the left will make the rudder go left.
In flight this will make the model turn to the left.
throttle Control
Moving the right stick to the top of the transmitter will
operate the motor. The throttle is proportional, so as you
move the throttle stick up, the speed of the motor will
increase, which increases the flying speed of the model.
We recommend flying at 1/4 to 2/3 throttle for your first
flight to learn the flying characteristics of your model.
use the following to bind the radio system.
1. Turn on the transmitter
2. Install the flight battery and connect the plug
3. Momentarily depress the 2 trim buttons on the throttle stick (you do
not need to hold them down)
4. The airplane will indicate that it is bound by movtng the controls
5. Check that the control surfaces are moving in the correct direction
Mode 1 or Mode 2?
Your Micro Boomerang is available with either a, Mode 1 transmitter (throttle on the right) or Mode
2 transmitter (throttle on the left). The best mode is the one you first learn on, it’s up to you.
(the instructions on this page relate to Mode 1 transmitters).