Erbauer ERB371GRD, Оригинальное руководство пользователя, Страница: 18 / 24

2300W 230MM ANGLE GRINDER
11. AUTO-STOP CARBON BRUSH (See Fig.7-1)
When the resin insulating tip(16) inside the carbon
brush(17) is exposed to contact the commutator(15),
it will automatically shut off the motor. When this
occurs, both carbon brushes(17) should be replaced.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at
the same time. Use only identical carbon brushes.
12.TO REPLACE THE BRUSHES(See Fig.7-2)
Remove the screw securing the motor brush cover.
Remove the cover, gently lift out, and pull the spade
connector free. Hold back the coil spring and slide
the worn brush out of the housing, carefully release
the spring. Locate the replacement brush, (in the
same orientation) whilst again holding back the coil
spring. Ensure the brush is located and free to move,
release the spring, it should now sit within the groove
on the brush. Re-attach the spade connector to the
terminal, replace the cover and secure.
Fig. 7-1
Fig. 7-2
A
B
15
16
17
A
B
15
16
17