Erbauer ERB110SSW, Руководство пользователя

Страница: 16 / 24

OPERATION
Note:
1) Your saw does not cut wood automatically. You
have to guide the wood against the blade for op-
eration.
2) When cutting thick timber or hardwood, be
particularly careful not to bend or twist the blade.
This will help to prolong blade life.
3) Do not assemble the flexible shaft when saw-
ing, otherwise the shaft will damage the spring.
1. On / Off switch (9) (see Fig.E)
To start the machine, press the on/off switch to
ON position (“I”). To stop, press the switch to OFF
position (“O”).
Note:
The machine is equipped with a magnetic
switch to prevent it being switched on again ac-
cidentally after a power failure.
2. Blade speed regulator (8) (see Fig.E)
The blade speed regulator allows you to set the
blade speed appropriate to the material to be
cut.
3. Carrying out internal cuts
1) To carry out internal cuts in a panel, firstly re-
move the blade.
2) Drill a 6.3mm hole inside the boundary of the
aperture to be cut from the panel.
3) Place the panel on the saw table with the drilled
hole above the blade access hole.
4) Install the blade through the hole in the panel
and adjust the blade tension.
5) When you have completed
the internal cuts, re-
move the blade from the blade holders and take
the panel off the table.
Fig.E