Erbauer ERB110SSW, Руководство пользователя

Страница: 15 / 24

70W SCROLL SAW
Fig.C2
3. Changing the blade
(see Fig.C1 & Fig.C2)
Remove the table insert.
Turn the blade tension knob (15) anticlockwise to
remove the tension from the saw blade (6).
Take the blade out of the top blade holder (3),
pressing down the upper pendulum arm as you
do so. Then take the blade out of the bottom blade
holder.
Pull the blade up and out.
Install the new blade in reverse order.
Note: Make sure the saw blade teeth point down
towards the saw table. If the teeth point upwards
the workpiece will be moved upwards during the
cutting action.
The blade holder has two slots to provide two
blade positions. Use slot
1
to cut in line with the
radial arm. Use slot 2 to cut at right angles to the
radial arm.
(Fig.C3)
Tension the blade by turning the blade tension
knob (15) clockwise (right-hand thread).
Note: Do not over-tighten the knob. This will help
to prolong the life of the saw blade.
4. Tilting the saw table (Fig.D)
Undo the table tilt lock knob (11). Position the
table to the required angle then tighten the lock
knob to secure.
Important:
For precision work you should first
carry out a trial cut and then re-adjust the tilt
angle as required.
After completing sawing on the tilted saw table
return to the horizontal flat position by undoing
the table tile lock knob (11) and positioning at o
degrees on the scale.
For precise work always double check the angle
of the work bench with a protractor or similar
angle measure.
Fig.C1
Fig.C3
Fig.D