Erbauer ERA563DRL, Оригинальное руководство пользователя

Страница: 14 / 20

OPERATING INSTRUCTIONS
Note: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for hammer drilling in
concrete, brick and stone as well as for light chiseling
work. It is also suitable for drilling without impact in
wood, metal, ceramic and plastic.
1. INSERTING AND REMOVING DRILL BIT IN SDS
Take care that the dust protection cap (2) is not
damaged when changing tools.
• Inserting (See Fig. 1-1)
Clean and lightly oil the bit before inserting. Insert the
dust-free bit into the bit holder with a twisting motion
until it latches.
The bit locks itself. Check the locking by pulling on the tool.
• Removing (See Fig. 1-2)
Retract back the bit holder locking sleeve (3) and pull
out the bit.
Warning: Your new Rotary Hammer generates
powerful forces to get your job done quickly and
effectively. These forces may cause inferior quality
SDS bits to break and jam in the chuck. We therefore
recommend that only high quality SDS bits be used
with this tool.
2. ON/OFF SWITCH WITH VARIABLE SPEED
CONTROL (See Fig. 2)
Depress to start and release to stop your tool. This
tool has a variable speed switch (7) that delivers
higher speeds with increased trigger pressure -
speed is controlled by varying the pressure applied
to the switch.
3. SWITCH LOCK-ON BUTTON
Depress the on/off switch (7) then the lock on button
(6) (See Fig. 2); release the on/off switch first and the
lock-on button second. Your switch is now locked
on for continuous use. To switch off your tool just
depress and release the on/off switch.
4. AUXILIARY HANDLE (See Fig. 3)
Slide the handle onto the hammer and rotate to
the desired working position. To clamp the auxiliary
handle rotates the handle clockwise. To loosen the
auxiliary handle, rotate the handle anti-clockwise.
Fig. 1-2
Fig. 1-1
Fig. 3
Fig. 2
Fig. 4
12