7
ECSP51
Getting
Started . . .
Transport and storage
> Stop the engine and engage the chain brake before transporting the product.
> Carry the product with the engine stopped, the guide bar and saw chain to the rear,
and the exhaust away from the body.
> Fit the guide bar cover on the saw chain during transportation or storage.
> Only carry the product in a horizontal position. Grip the front handle in a manner that
the product is balanced horizontally.
> Secure the product when transporting in a vehicle to prevent turnover, fuel spillage
and damage to the product. Use line or ratchet tie-down if necessary.
> Store the product and fuel so that there is no risk of leakages or fumes coming into
contact with sparks or naked flames from electrical equipment, electric motors,
relays/switches, boilers etc.
> For longer periods of storage or transportation the fuel and chain oil tanks must be
emptied. Dispose of waste oil and fuel at a local petrol station, local authority centre
or where facilities exist.
> Store fuel and oil in an approved container specifically designed for that purpose.
> Clean the product and have it serviced before any long-term storage.
Causes and operator prevention of kickback
Kickback may occur when the nose or tip of the guide bar touches an object, or when
the wood closes in and pinches the saw chain in the cut.
Tip contact in some cases may cause a sudden reverse reaction, kicking the guide bar
up and back towards the operator.
Pinching the saw chain along the top of the guide bar may push the guide bar rapidly
back towards the operator.
Either of these reactions may cause you to lose control of the saw which could result
in serious personal injury. Do not rely exclusively upon the safety devices built into the
chain saw. As a chain saw operator, take several steps to keep the cutting jobs free
from accidents or injuries.
Kickback is the result of tool misuse and/or incorrect operating procedures or conditions.
It can be avoided by taking proper precautions as given below:
>
Maintain a firm grip, with thumbs and fingers encircling the chain saw handles,
with both hands on the saw and position your body and arm to allow you to
resist kickback forces.
Kickback forces can be controlled by the operator, if proper
precautions are taken. Do not let go of the chain saw.
>
Do not overreach and do not cut above shoulder height.
This helps prevent
unintended tip contact and enables better control of the chain saw in unexpected
situations.
Safety information