5
Then insert two pieces of CR123A batteries included in the package. (If power adaptor is not used,
insert batteries only).
2.3.
Register Admin Number
Admin number is authorized to make configurations, change & delete settings of the device. And also will
receive all alerts with SMS and/or phone calls. Other users will only receive alerts and will not be able to
make configurations.
The LED will blink a few times until it is connected to an available network. Please wait for LED
becomes solid ON. Once LED is ON; that means device is connected to a GSM network and ready to
work.
Now please call the device’s number with your phone. Once you hear the ringing volume, your
number is registered to devices memory as ADMIN NUMBER.
Then the LED will blink and device will send you an SMS including “ADMIN OK” message. Once you
received this message that means device is ready to work and now operating! If you want to make
some changes on settings please continue from below steps.
2.4.
Send Configuration Commands
Press config button for 3 seconds and wait LED becomes solid ON. Now your device is waiting for a
configuration SMS from you (note that timeout is 2 minutes).
Please note all commands should start with an admin password (except RESET command). Default
password is “1111”. Also, it is possible to send one or several commands in one SMS.
Commands should be written in “big letters” (correct one: 1111 NEWP:3333, wrong one is: 1111
newp:3333).
There
should
be
a
space
character
between
independent
commands
e.g.:
1111<space>NEWP:1234<space>DEL1<space>DISABLE
Device is case sensitive; please pay attention to text message ingredients.
Attention: If you write the password wrong you will receive an SMS including “WRONG PSWR” text. In
that case device will keep in configuration mode. Please wait until LED becomes solid again and send a
configuration SMS with correct password. Otherwise device will keep the same settings and continue
operation after 2 minutes timeout and LED will become OFF.
Below is the list of commands:
DESCRIPTION
COMMAND
DEFAULT
Change Password
NEWP:XXXX
1111
Add / Change User1
TEL1:+XXXXXXXXXX
Add / Change User2
TEL2:+XXXXXXXXXX
Delete User1
DEL1
Delete User2
DEL2
Enable Keep Alive
ENABLE
Enabled (Weekly)
Disable Keep Alive
DISABLE
Enabled (Weekly)
Reset Device
RESET
Table – 1 “Commands List”