Equus 250L, Руководство пользователя

Страница: 7 / 15

NOTE: You cannot adjust the throttle very much, as you need to maintain 540 rpm PTO speed. (A plus or minus
20 rpm could be tolerated.)
1MPH will travel 88 feet in 60 seconds 4MPH will travel 88 feet in 15 seconds
5MPH will travel 88 feet in 12 seconds 6MPH will travel 88 feet in 10 seconds
7.5MPH will travel 88 feet in 8 seconds
After selecting gear and throttle setting to give desired speed, mark the throttle position in some convenient
manner. Check PTO speed to make sure it is near 540 rpm.
3. Check rate chart for suggested setting for material type to be spread.
4. You are now ready to make a trial run. To assure accurate results. Close the feed gates and put in a
pre-determined amount of the material to be spread. Spread this and check the results. Make final adjustments to
obtain desired results.
CAUTION!
KEEP ALL PERSONS AWAY FROM THE ROTATING SPREADER FAN AND THE PTO SHAFT! NEVER OPERATE
WHEN ANYONE IS WITHIN 50FEET OF SEEDER/SPREADER.
Three spreading possibilities
A simple adjustment of the lower level allows direction of distribution towards the right side or towards the left side of
the tractor operator.
MAINTENANCE
1. The hopper should be washed after use, especially after use with corrosive material such as fertilizer., salt or ice
melting compounds. When dry, oil thoroughly.
2. The gearbox is filled with lubricant and sealed at the factory. If operated and stored properly, the gearbox will
provide a long, trouble-free service life. If disassembly of the gearbox should ever be required, it is important that
the box be re-filled with a good quality grease and that the box halves are resealed with silicone adhesive.
3. Grease PTO universal joints after every 8 hours of operation. Lubricate steel tube and shaft so they telescope
freely.
4. Always store seeder/spreader in a clean, dry place.
5. Before using, check to make sure all nuts and bolts are tight.
6. Paint any bare metal or rusty spots for longer life.
6