Equinox Systems Megabar System EQLED63, Руководство пользователя

Страница: 5 / 12

Operation modes:
The Equinox Megabar has five modes of operation as follows:
1, Sound active mode
To select the sound active mode, press the “MODE” button to show “SOUND MODE” in the LCD
display window. Now press the “SETUP” button and use the “UP” and “DOWN” buttons to
adjust the sound sensitivity level (SENS00-31) and press the “SET UP” button again to adjust the
frequency level (FQN01-99). Finally press the “SETUP” button to confirm your setting.
2, Built-in programmes mode
To access the built-in programme mode, press the “MODE” button to show “01.STATIC” in the
LCD display window. Now press the “SETUP” button and use the “UP” and “DOWN” buttons to
choose one of the 14 built-in programmes (01-14) (see table overleaf).
To choose one of the seven colours in the “STATIC” mode, press the set “SETUP” button and
use the “UP” and “DOWN” buttons to choose one of the following 7 colours:
(1) RGB = all on, (2) BR = purple, (3) B = blue, (4)GB = cyan,
(5) G = green, (6) RG = yellow, (7) R = red, BLA = blackout.
To adjust the speed level in the remaining 13 built-in programmes, press the SETUP” button and
use the
“UP”
and
“DOWN”
buttons to set the desired speed level (00-99).
To adjust the flash speed press the “SETUP” button and use the “UP” and “DOWN” buttons to
set the desired flash speed level (00-99). Finally press the “SETUP” button to confirm
your setting.
3, Auto Run mode
To select the Auto run mode, press the “MODE” button to show “AUTO RUN” in the LCD display
window. Now press the “SET UP” button to adjust the frequency level (FQN01-99). Finally press
the “SETUP” button to confirm your setting. The unit will now run all 13 built-in programmes one
after another.
4, DMX mode
To select the DMX mode, press the “MODE” button to show “DMX MODE” in the LCD display
window. Press the “SETUP” button and use the “UP” and “DOWN” buttons to set a DMX
address from 001-512. Now press the “SETUP” button again and use the “UP” and “DOWN”
buttons to choose one of the 3 DMX channel settings (6CH, 9CH or 15CH) Finally press the
“SETUP” button to confirm your setting. (see DMX chart). The starting address for this fixture is
001.
5, Slave mode
To select Slave mode, first link the units together via 3-Pin XLR cable(s), press the “MODE”
button to show “SLAVE MODE” on all of the slave units. Now the slave units will follow in
conjunction with the master unit.
NOTE: If the Mega Bar is being used in conjunction with the MB-1 foot controller any
number of Mega bars can be controlled via the foot controller by setting all bar systems
into “SLAVE” mode.
NOTE: The frequency level (FQN01-99) adjusts how many times the programme repeats
before moving to the next programme.
Equinox Megabar Operation modes