www.prolight.co.uk
Giga Bar System
User Manual
8
Sound active mode:
To select the sound active mode, press the
“MODE”
button to show
“SOUND MODE”
on the LCD display.
Now press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to adjust the sound
sensitivity level (SENS00-31) and press the
“ENTER”
button again to adjust the frequency level
(FQN01-99). Press the
“ENTER”
button to confirm your setting.
To exit out of any of the above options, press the
“MODE”
button.
Built-in programs:
To access the built-in program, press the
“MODE”
button to show
“01.STATIC”
on the LCD display.
Now press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to choose one of the
14 built-in programs (01-14) (see table overleaf).
To choose one of the seven colours in the
“STATIC”
mode, press the press the
“ENTER”
button and use
the
“UP”
and
“DOWN”
buttons to choose one of the following 15 colours.
To adjust the speed level in the remaining 13 built-in programmes, press the
“ENTER”
button and use
the
“UP”
and
“DOWN”
buttons to set the desired speed level (00-99). To adjust the flash speed press
the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to set the desired flash speed level (00-99).
Press the
“ENTER”
button to confirm your setting.
To exit out of any of the above options, press the
“MODE”
button.
Auto mode:
To select the Auto run mode, press the
“MODE”
button to show
“AUTO RUN”
on the LCD display.
Now press the
“ENTER”
button to adjust the frequency level (FQN01-99).
Press the
“ENTER”
button to confirm your setting.
The unit will now run all 15 built-in programmes one after another.
To exit out of any of the above options, press the
“MODE”
button.
Slave mode:
To select slave mode, first link the units together via 3-Pin XLR cable(s), press the
“MODE”
button to
show
“SLAVE MODE”
on all of the slave units. Now the slave units will follow in conjunction with the
master unit. Press the
“ENTER”
button to confirm your setting.
To exit out of any of the above options, press the
“MODE”
button.
IEC power output on/off mode:
To turn the IEC power ouput 1 on or off, press the
“MODE”
button to show
“LIGHT 1”
on the LCD display.
Now press the
“ENTER”
button to turn the IEC power ouput 1 on or off. To turn the IEC power output 2 on
or off, press the
“MODE”
button to show
“LIGHT 2”
on the LCD display. Now press the
ENTER”
button to
turn the IEC power output 2 on or off.
To exit out of any of the above options, press the
“MODE”
button.
NOTE: If the Giga bar is used on continental 110V mains supply the voltage output will also be 110V.
NOTE: If the Giga bar is being used in conjunction with the GB-1 foot controller any number of Giga bars can be
controlled via the foot controller by setting all bar systems into “SLAVE” mode.
NOTE: The frequency level (FQN01-99) adjusts how many times the program repeats before moving to the next program.
