20
MAINTENANCE
Your
-Dryer has been designed to operate with easy maintenance.
Follow these simple maintenance procedures to obtain optimum performance:
1. Ensure that your machine was installed according to the correct installation procedures
detailed in this Manual.
2. Do not use solvents either to clean the machine or to wash clothes.
3. Keep the inside of the detergent dispenser clean;
4.
-Dryer is a self-cleaning pump. It is therefore not
necessary to carry out cleaning and maintenance operations. However, objects (such as
buttons, coins, etc) may sometimes accidentally drop into the pump. Since these can’t be
expelled through the drain hose, please remove the cover panel at the bottom of the unit
by holding down on the small tab and pulling the cover down (Fig. 11), remove the pump
cover, and carefully inspect the inside. (Fig.12). Be sure to close the cover after cleaning.
The tab should be gently pulled up until you hear a click.
-
Switch
off
the
washing
machine
.
-
Open
the
service
flap. (bottom right corner)(Fig. 11)
-
Carefully
unscrew
the
coin-trap
cover. A
little
residual
water
will
flow out.(Fig. 12)
-
Remove
foreign
objects
/
fluff
from inside
and
clean
the
interior
.
(Fig. 13)
-
The pump impeller wheel must be able to rotate. Remove detergent residue and fluff from the pump cover
thread and pump housing.
-
Insert
the
coin-trap
cover
and
screw
tight
.
Cleaning the coin trap
(Fig.11)
(Fig.12)
(Fig.13)
Cleaning the Detergent drawer and Recess
-
Press the release lever on the inside of the drawer and pull it out.(Fig. 14)
-
Remove the cap from the compartment of softer.
-
Wash all of the parts under running water.
-
Clean the drawer recess with an old toothbrush.(Fig.15, Fig. 16)
-
Reinsert the cap (Pushing it firmly into place).
-
Push the drawer back into place.
-
Run a rinsing program without any laundry in the drum.
(Fig.14)
(Fig.15)
(Fig.16)
Содержание EZ 4000 CV
Страница 1: ...OWNER S MANUAL FRONT LOADING SUPER COMBO...