Equalizer International FA3TM, Инструкция оператора

Страница: 19 / 34

FLANGE ALIGNMENT TOOLS
OPERATOR INSTRUCTION MANUAL
PAGE 17
4.
Attach the torque wrench to the
screw bolt and tighten in a
clockwise direction until the joint
comes into alignment.
The torque wrench should be set
at staged increases, e.g. 10 ft/lbs,
20ft/lbs until the maximum
setting of 50ft/lbs (67.8 N/m) is
reached.
5.
Once in alignment the bolts may
be inserted and tightened.
After replacing all of the bolts (apart
from the bolt which will go into the
bolt-hole in which the FA3TM is
located), remove the tool by
reversing steps 2 - 4.
Insert the last bolt and tighten.
The torque wrench
will click when the full
50 ft/lbs (67.8 N/m) is
achieved - exceeding
50 ft/lbs will result in
damage to the tool
Care should be taken not to drop any of the component parts when
removing them from the flange joint. This action will prevent injuries to
either the operator’s lower limbs, or to passers-by.
TORQUE
WRENCH
SCREW
BOLT