5.5.1 Programming favourites
•
Press and hold down the “FAV” button for at least 3
seconds to switch to programming mode.
•
“LOCATION” will appear on the display panel, along with
the current memory location and the number of the region
assigned to it. If a region has not been assigned to a
memory location, “--” will appear instead of a number.
•
Use the <+> button to select a region from the lists in
Appendix 10.2. “--” is displayed after region 89. Select
this to deactivate the corresponding memory slot and skip
it subsequently during display selection.
•
To go to the next memory location, press and immediately
release the “FAV” button and use the <+> button to select
the next region you require.
•
Continue until you have assigned regions to all five
memory locations. If you do not wish to use all five memory
locations, wait at least 20 seconds before pressing another
button. The unit will automatically revert to normal mode.
•
Once you have programmed memory location 5, the unit
will automatically revert to normal mode.
6.1 Alarm function
•
To set the alarm time, press and hold down the
<ALARM> button for three seconds. “ALM” and the
hour indicator will flash. Use the <+> button to set the
hours. Press the <ALARM> button again to activate
the minutes setting. The minutes indicator flashes.
Use the <+> button to set the minutes. Press the
<ALARM> button again to exit the mode for setting
the alarm time.
•
Press the <ALARM> button to activate or deactivate
the alarm. When the alarm is activated, the
corresponding symbol “((•)))” will be displayed.
6. Operation
