05232022JA
U-00221
7
Step 10
: Insert the Center Support Bar (o) into the upper top groove on the back of the frame with the bottom end
near the approximate center point of the frame and rotate it in at an angle so that both ends of the bar are in alignment
with the groove.
Installation
Step 11
:
Measure the overall length and height of the frame and drill holes for the top brackets. Line up the wall
brackets with the drilled holes on the installation location and screw them in using a Phillips screwdriver. If not
installing into a structural wood stud, use a hollow wall anchor then screw in the M5x50 wood screws with a
screwdriver. Make sure the brackets are leveled.
Diagonal Sizes of 150” and below use 4 x wall brackets
Diagonal Models 150” and below use 1 x
Center Support Bar
Diagonal Models above 150” require 2 x
Center Support Bars
Model/Size
X = Wall bracket distance
X1 = Bracket hole distance
Y = Top/Bottom Wall Bracket Height
110”
1280mm (50.39”)
30mm (1.18”)
1410mm (55.51”)
120”
1390mm (54.72”)
30mm (1.18”)
1530mm (60.24”)
135”
1550mm (61.02”)
30mm (1.18”)
1720mm (67.72”)
150”
1720mm (67.72”)
30mm (1.18”)
1900mm (74.80”)
138”
1600mm (63”)
30mm (1.18”)
1410mm (55.51”)
Don’t tighten the screw to allow
the screen to move up and down
j.
k.
Place a center
support bar 30 cm
(11.8”) apart from
the center (red line).
