04252019JA
4
Screen material tension adjustment
(
4mm Allen Wrench required and not included
)
Remove the weight bar end cap to expose the
adjustment tension knob. This knob has a 4mm Allen
port. Insert your 4mm Allen Wrench and push in the
adjustment tension knob, turn clockwise and your
screen will gain more tension. Turn the Allen Wrench
counter clockwise and the screen will lose tension.
Please note this adjustment is not necessary as the
tension of the screen has been pre-set to its factory
drop setting. If you would like to adjust the screen
tension, please contact EPV Screens for assistance to
avoid damaging the screen and voiding your warranty.
Power Max Sonic 2 Series | Controls and Accessories
A. IR
Remote
B. RF
Remote
C. Wall
switch
control box
D. 5-12-volt
trigger
cable
E. IR
extended
“eye”
receiver
F. Wireless
5-12v
trigger
cable
G. AAA
batteries
H. Bubble leveler
Screen operation
Electric Current
: Depending upon region, your screen will operate at 100v, 110v, or 220v voltage.
1. After ensuring the power outlet & screen are compatible (voltage), plug the power cord into the power outlet.
2. Once the screen has power, you’ll be able to control it using any of the 6 methods described below.
6 ways to control your Saker Tab-Tension
1.
IR remote control
(
Item A, Fig 1
): The Infrared functions by direct line of sight
contact using a beam range of 30 feet. Aim the IR remote at the circular window
located on the left side of the screen.
2. IR “Eye” Receiver
(
Item E, Fig 2
): The IR “Eye” Receiver plugs directly into
the screen’s RJ-45 input to present a low-profile line-of-sight control option for
your IR remote control. It is an extended eye-receiver to accommodate a recessed
ceiling installation.
3. RF Remote Control
(
Item B, Fig 1
): The radio waves
eliminate the need for a direct line of sight and has a range
of 100 feet.
Fig.2
UP
STOP
DOWN
IR “eye” receiver
Fig.1
IR/RF remote
