04252019JA
2
Do not use this unit under the following circumstances.
•
Disconnect the power cord if exposed to moisture, rain, wind, electrical storms or snow.
•
Avoid exposure to direct sunlight or any of the conditions stated in the previous bullet point.
•
Keep away from fire or other high temperature heat sources.
•
Cut off the power supply first before attempting maintenance or removal.
•
Do not attempt to use this screen if there are obvious signs of damage.
•
To avoid possible injury and/or an electric shock, do not attempt to use the screen if there is
obvious damage or if there are any evident broken parts.
WARNING
Individual modifications to this product are prohibited and will void the manufacturer’s warranty. Please
contact the EPV Screens Customer Service Team with any questions.
NOTE
:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
The product settings are designed to provide reasonable protection against any radio interference within a
residential installation. If properly installed, the Saker Tab-Tension screen may suffer from RF interference
from other home electronics.
Although radio interference affecting other household electronics is unlikely, the following steps can be
taken should RF interference occur.
✓
Reorient or relocate the receiving antenna on the device that may be casing the interference.
✓
Increase the distance between the screen and the interfering device’s receiver.
✓
Connect the projection screen to another power source apart from the interfering device.
Pre-Installation
1.
Carefully unpack the screen.
2.
Always handle the screen upright on a clean, level surface.
3.
Keep the screen out of contact with foreign particles such as dust, sawdust, and/or liquids.
NOTE
Regardless of the mounting method, each screen should be securely installed so that vibrations or pulling on
the viewing surface will not cause the casing to become loose or fall. Included are complimentary mounting
screws that may or may not be appropriate for the installation you are attempting. Always use the correct
anchors to safely secure the screen.
This product is for professional integrators only.
Hardware Parts List
Please make sure all parts listed below are included before proceeding with the installation.
A.
Wall/Ceiling
mount
bracket x2
B.
M5x60
Screw
x6
C. M12
Dry-wall
anchor x6
D. Bracket
connector x2
(Installed on
the housing)
E. M5x11
Bolt Screw
x4
(Screw on
the D parts)
F.
M5x25M
M round
head cross
screws x2
G.
M5x30M
M eyebolt
screw &
M5 nut x2
H.
Carabiner
x2
