Rev.072512-JA
4
www.elitescreens.com/epv
UP
Stop
Down
6
.
In-wall RJ45 Module
: The RJ45 module connects to a local wall switch for Up/Down control of your
electric screen. Please follow the diagram below for instructions on how to connect this accessory
.
Steps to attach Elite Screens Motorized Screen to your local wall switch
1. Attach the
in-wall module
(Part #: ZIW-Module) to your local wall switch as shown in diagram above.
2. Attach an RJ45 Ethernet cable (not included) to the ZIW-Module and the other end to the RJ45 input
on your Elite electric screen
3. After testing the connection, place the in-wall switch module in/on the wall and wire the Ethernet
cable into the wall and complete the setup.
Hardware Parts List for Peregrine Tension Series
Please make sure all items listed below are included before proceeding with the installation.
Installation Instructions
1.
Insert each
Bolt (B)
through the right & left slide channel located on the top of the screen’s case.
Hardware Parts List
QTY
A. Screw & Dry Wall Anchor
2or 3
B. Bolt
2 or 3
C. Masonry Screw & Anchor
2 or 3
D. Extruded Hanging Bracket
2 or 3
4. IR Remote Control:
The Infrared functions by direct
line of sight contact with a beam range of 30 feet.
5. RF Remote Control:
The radio waves eliminate the
need for a direct line of sight with a range of 100 feet.
A
B
C
D
120”& above models x 3
Note
: Please be aware that Ethernet cables have length
limitations so please make a test first before concealing the
cable into the wall.
channel
