12282021JA
6
Step 13:
After attaching the entire black backing to the frame with the velcro, use the
spring hook (d)
to
attach the
spring (e)
to the hole located on the screen material’s outer edge in the following order.
Make sure the spring hook goes over the rod
.
Attach the four corners first (1).
After those are secure, attach the vertical portions of the material, begin in the center, and move towards the
corners (2). Lastly, attach the horizontal sections of the material by connecting the center of the material
and make your way towards the corners (3).
Note (after all springs have been attached):
Correct material installation
–Corners of the screen material are properly wrapped around the corner
edges of the frame and material is evenly tensioned and flat, creating a nicely taut surface.
Incorrect material installation
–The corners of the screen material are not properly wrapped along the
edge of the frame leaving the material with unbalanced tension and an uneven finish. To correct, detach
springs from material at the corner(s) where material does not lie flat along the edge of the frame, reposition
the material so that it lies flat and wraps along the edge of the frame, and reattach springs to the material.
Center Support Bar
1
1
1
1
2
3
2
3
To avoid ripples forming in the material it is imperative that all of the corners are properly wrappedaround the
edges as illustrated in the check mark diagrams.
Attach springs to holes
Repeat on all corners
