Modello - Modèle - Model
Modell - Modelo
DELIGHT LITE
DELIGHT PRIME
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
20/68
N° DOC
UM000327
17. OUTER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
For a good preservation of the cabinet’s body a periodical cleaning is necessary.
1.
EXTERNAL BODY:
When necessary, the external body should be cleaned with a cloth and a neutral soap and water
solution.
2.
STAINLESS STEEL SURFACES:
Wash with warm water and mild detergent, rinse well and dry with soft cloth. Avoid
scouring pads etc. which will spoil the finish of the stainless steel.
3.
SURFACES IN PLASTIC MATERIAL:
Wash with warm water and mild detergent, rinse well and dry with soft cloth;
under no circumstances should alcohol, methylated spirits or solvents be used.
4.
GLASS SURFACES:
Only use products specifically designed for glass cleaning; It is not advisable to use ordinary
water which can leave a film of calcium on the surface of the glass.
18. INNER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
Theese units make an automatic defrosting in the displayng tank.
The storage compartment should be defrosted when frost on the walls has a thickness of more than 5 mm.
We recommend to make the defrosting of storage compartment and, at the same time, the cleaning of displayng tank;
proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature.
2. Before cleaning the inside temperature must be equal to the ambient temperature; place a container of warm but
not boiling water inside the storage compartment, standing on a piece of cardboard, and leave the door closed for
about 30 min.
3. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
4. Avoid water entering into the appliance lighting units.
5.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process, other
than those recommended by the manufacturer.
19. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate pre-
established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
• Press the (C)
key
in order to see on display the temperature set point.
•
Press the (A) key or the (B) key
in order to increment or decrement the temperature set point
•
Press the (C) key
in order to store the
new
temperature set point.
A
E
B
D
C
A
)
Button to increase temperature
B
)
Button to decrease temperature
C
)
Button to show set temperature
D
)
Automatic defrosting button (press for defrosting start)
E
)
Light switch
