EPTA EIS 165.3 N/P KW, Руководство по обслуживанию, Страница: 34 / 45

SERVICE MANUAL EIS 165.3 N/P KW (short version) inglese
Autori: Serralunga M. 14/10/2021
34
NO COPYING IN ANY FORM WITHOUT WRITTEN PERMISSION FROM EPTA QUALITY MANAGEMENT
6. MAIN CABINET FUNCTIONS
6.1
DISPLAY UNIT AND MAIN PARAMETERS
6.2
USE OF LEDS
SIGNAL MODE FUNCTION
ON Compressor enabled
FLASHING Anti ‐ short cycle delay enabled
ON Defrost enabled
FLASHING. Drip time in progress
ON Fans enabled
FLASHING Fans delay after defrost in progress
ON An allarm is occurring
F
ON Continuous cycle is runnirng
ON Energy saving enabled
ON Light on
ON Auxiliary relay on
ON Measurement unit
FLASHING Programming phase
6.3
HOW TO CHANGE A PARAMETER VALUE
To change any parameter, operate as follows:
1) Enter the Programming mode by pressing both
SET + DOWN keys for 3 sec (the “°C” or
“°F” LED will start blinking).
2) Select the required parameter and then press the SET key to display its value.
3) Use UP or DOWN keys to change its value.
4) Press SET to store the new value and move to the following parameter.
To exit : press both SET + UP keys or wait for 15 sec without pressing any key.
NOTE : the set value is stored even when the procedure is exited by waiting the time-out to
expire.
1
2
3
5
4
1. Light switch
2. Automatic defrosting button
3. Button to show set temperature
4. Button to decrease temperature
5. Button to increase temperature