Epson TM-U200P, Информационное руководство

Страница: 41 / 55

Rev. A Command Descriptions 1-31
TM–U200/U200P Information Manual
(1) When m = 1 or 49, GS V m executes a partial cut (one point left uncut)
(2) When m = 66, GS V m n executes a partial cut (one point left uncut) after paper is fed
[cutting position (n
×
approximately 1/144 inch)].
When using the above commands, there is a gap between the auto-cutter position and the print
position. These commands are effective only when input at the beginning of a line.
The TM-U200D/U200PD printers are not equipped with the auto-cutter unit; therefore, the GS V m
command is ignored. The GS V m n command executes paper feeding to the manual cutting position.
Miscellaneous Function Commands
The TM-U200/U200P printers support the following miscellaneous function commands.
Command Name
ESC @ Initialize printer
GS I Transmit printer ID
ESC p Generate pulse
ESC = Select peripheral device status
DLE ENQ
Real-time request to printer
GS z 0 Set on-line recovery wait time
ESC @
[Name] Initialize printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
Program Example Print Sample
PRINT #1, " AAAAA"; CHR$(&HA);
PRINT #1, CHR$(&H1B);"J";CHR$(250);
PRINT #1, CHR$(&H1D);"V";CHR$(1);
←
Cut paper
PRINT #1, " BBBBB"; CHR$(&HA);
PRINT #1, CHR$(&H1D);"V";CHR$(66);CHR$(0);
←
Feed paper and cut
Partial cut (one point left uncut)
AAAAA
Paper fed to the cutting position and
BBBBB
partial cut (one point left uncut)
performed