Epson TM-U200P, Информационное руководство

Страница: 29 / 55

Rev. A Command Descriptions 1-19
TM–U200/U200P Information Manual
ESC c 3 n selects the paper sensor that outputs a paper-end signal to the parallel interface when a
paper-end is detected. The default setting is when all sensors are enabled (n= 15).
It is possible to select multiple sensors to output signals. Then, if any of the sensors detects a paper
end, the paper end signal is output. This command is available only with a parallel interface and is
ignored with a serial interface.
The paper near-end sensor is an option; therefore, if the sensor is not equipped, the settings of bits 0
and 1 of this command are not effective.).
Print Position Commands
The TM-U200/U200P printers support the following commands for setting the print position.
Command Name
HT Horizontal tab
ESC D Set horizontal tab positions
ESC a
Select justification
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper roll near-end sensor disabled.
On 01 1 Paper roll near-end sensor enabled.
1
Off 00 0 Paper roll near-end sensor disabled.
On 02 2 Paper roll near-end sensor enabled.
2
Off 00 0 Paper roll end sensor disabled.
On 04 4 Paper roll end sensor enabled.
3
Off 00 0 Paper roll end sensor disabled.
On 08 8 Paper roll end sensor enabled.
4-7 — — — Undefined.
Program Example
PRINT #1, CHR$(&H1B);"c3";CHR$(4);
←
Only paper roll end sensor enabled.