Epson PP 408, Руководство пользователя

Страница: 33 / 135

Configuring the printer Configuring the printer
3-15 3-16
S S
Tear-off-mode / Cut-mode The setting TEAR - OFF 1 S causes the paper to move to the tear off position
In case the selection of paper exit for the printer with cutter is "STACKER", when the print job has been completed by a form feed command and no new
each form will be cut automatically and laid down into the stacker. print job has been received within one second. If the paper is not torn off and
If for the printer with cutter "BATCH" is selected or the printer without cutter new printing data are received the paper moves back into the printer to allow the
is in use, the following choices of either automatic feeding into the tear off following page to be printed.
position or automatic cutting are available:
S S
NO The setting CUT 10 S ( printer with cutter ) causes the form to be cut if no
S S
TEAR - OFF 10 S further printing data have been received within a print job for a period of 10
S S
TEAR - OFF 1 S seconds. After cutting, the paper moves immediately into the top of form
S S
CUT 10 S only for printer with cutter position of the next page. This setting supports applications lacking a
S
CUT 1 S only for printer with cutter programmed form feed after completion of a print job.
S
CUT 1 S NO FF only for printer with cutter
S
CUT MODE ON only for printer with cutter The setting CUT 1 S ( printer with cutter ) causes the form to be cut if, after a
Disregarding these settings for the printer with cutter , the printer will always job for a period of 1 second. After cutting, the paper moves immediately into the
cut the paper when a switch from one tractor to the other has been initiated. In top of form position of the next page.
this case the printer without cutter gives the message TEAR OFF
Furthermore, all settings can be overruled by software (Command SPSIF, cut The setting CUT 1 S NO FF ( printer with cutter ) has the same function as
mode on). CUT 1 S but is independent of receiving of a form feed command.
Note:
If in the printer with cutter the page before the last gets cut it is not By the function CUT MODE ON and PATH = BATCH in PAPER EXIT the
possible to print on the very last page of the fanfold batch because it has printer with cutter will cut continuous forms into single sheets and feed them to
left the transport pins of the tractors. the rear. Use the optional Cut Sheet Tray to collect the sheets. The application
The setting NO means, that neither automatic feeding into the tear off position otherwise the printer is unable to through out the sheet.
nor automatic cutting is performed. It is appropriate for batch output of
continuous forms.
The setting TEAR - OFF 10 S causes the paper to move into the tear off
position if no new printing data have been received within 10 seconds. This
setting supports applications lacking a programmed form feed after the
completion of a print job. If printing data are received for the page at the tear off
position after 10 seconds the page is moved back so that printing can resume at
the last print position. If the page has already been torn off printing will be
continued at the top of the next page.
form feed command , no further printing data have been received within a print
has to control page length. The page length must be at least three inch,