2
Safety Instructions
When setting up your printer
Observe the following when setting up the printer:
❏
Do not block or cover the vents and openings in
the printer.
❏
Power supply cords should be placed to avoid
abrasions, cuts, fraying, crimping, and kinking. Do
not place objects on top of power-supply cords
and do not allow the AC adapter or power-supply
cords to be stepped on or run over. Be particularly
careful to keep all power-supply cords straight at
the ends and the points where they enter and
leave the AC adapter.
❏
Use only the power-supply cords that comes with
this product. Use of another cord may result in fire
or electrical shock, or injury.
❏
The AC adapter model A381H is designed for use
with the printer with which it was included. Do not
attempt to use it with other electronic devices
unless specified.
❏
Use only the type of power source indicated on
the AC adapter's label, and always supply power
directly from a standard domestic electrical outlet
with the AC power cord that meets the relevant
local safety standards.
❏
Avoid using outlets on the same circuit as
photocopiers or air control systems that regularly
switch on and off.
❏
Avoid using electrical outlets controlled by wall
switches or automatic timers.
❏
Keep the entire computer system away from
potential sources of electromagnetic interference,
such as loudspeakers or the base units of cordless
telephones.
❏
Do not use a damaged or frayed power cord and
the AC adapter.
❏
If you use an extension cord with the printer, make
sure that the total ampere rating of the devices
plugged into the extension cord does not exceed
the cord’s ampere rating. Also, make sure that the
total ampere rating of all devices plugged into the
wall outlet does not exceed the wall outlet’s
ampere rating.
