Epson PhotoPC 2100Z, Руководство по обслуживанию

Страница: 68 / 108

PhotoPC 2100Z Revision E
Adjustment Tools 62
5.2.3 Explanation of Error Codes
If any error occurs during execution of these adjustment programs, the LCD monitor of
the camera displays the error code. This section describes the errors signified by the
respective error codes and corrective actions to be taken at the occurrence of such
errors.
†
0: Any error other than specified
„
Corrective action
Perform the adjustment again.
†
1: Battery adjustment error
„
Corrective action
Check the conditions under which the adjustment is performed. For example,
check the power voltage and camera temperature.
†
2: CCD adjustment error
„
Corrective action
Check the conditions under which the adjustment is performed. Perform the
adjustment again and if a similar error recurs, replace the Lens Assy (with
CCD) with a new one.
†
3: CCD adjustment error
„
Corrective action
Check the conditions under which the adjustment is performed. Perform the
adjustment again and if a similar error recurs, replace the Lens Assy (with
CCD) with a new one.
†
4: CCD adjustment error
„
Corrective action
Check the conditions under which the adjustment is performed. Perform the
adjustment again and if a similar error recurs, replace the Lens Assy (with
CCD) with a new one.
†
5: Strobo adjustment error
„
Corrective action
Check the conditions under which the adjustment is performed. Perform the
adjustment again and if a similar error recurs, replace the PCB-Strobe Assy
with a new one.
C A U T I O N
„
Without firmware installation, the adjustment by CF
card has the counter that control to adjustment count on
each adjustment item. The counter is up to ten times.
When count up, the camera will not accept more
adjustment setting. At that time, perform the following
program;
Erase.c21
How to use is the same as another extension “c21” files.
But, if you perform the above program once, you must
perform the adjustments again from BC adjustment to
USB writing. Because, this program reset the adjustment
value without the firmware.