Solving Problems
|
27
Solving Problems
If you have a problem with your LabelWorks,
check the display or the troubleshooting
suggestions below.
Error messages
Insert tape
Turn the power off and install a
tape cartridge.
Check tape!
An incompatible tape cartridge
has been installed. Check the tape
cartridge.
Check tape
cartridge
Check battery
The batteries may be running out
or installed incorrectly, non-
alkaline batteries are being used
with alkaline batteries, or old and
new batteries are being used
together. Turn the power off and
replace batteries with new ones,
or use the optional AC adapter.
Make sure new batteries are
installed correctly.
Too many lines
You have exceeded the maximum
number of lines (4). Press
to
delete the lines indicated.
Seq. num. only 1
Sequence numbers have already
been set. You can only enter one
sequence number per label.
Text too long
Entered text is too long for the
specified label length. Press
and adjust the label length or
make text shorter.
Text is too long.
Continue?
Entered text is too long for the
specified label length. Press
to confirm and continue printing.
The label length will be adjusted
automatically.
Text will be
deleted. OK?
When creating labels with a
special format, the current text
will be deleted. Press
to
delete the text and show the
special format.
Fill every digit
Entered values for barcodes are
incorrect. Make sure the barcode
format is supported and that the
correct number of values is
entered.
Load wider tape
Unable to print on the current
tape. Use a wider tape.
Overheated!
The print head is too hot. Turn the
power off and take out the tape
cartridge. Allow the print head to
cool before trying to print again.
cable.book Page 27 Wednesday, May 22, 2013 3:25 PM
