Options
27
R
R4CD180
Setup Guide
Rev. C
SETUP.FM
A5 size
12/18/03
Proof Sign-off:
KOW N.Mizuno S.Koide
H.Kimura
NOC K. Lee
Installing the Network Image Express Card
Install the Network Image Express Card in your scanner by
following the steps below.
1. Turn off the scanner. Unplug any power cords, and then
disconnect all cables from the back panel of your scanner.
2. Remove the two screws using a cross-head screwdriver, and
then remove the plate. Be sure to keep both screws; you may
need to use them again if you re-install the shield plate.
3. Insert the Network Image Express Card in your scanner’s
optional interface slot and then tighten the screws.
c
Caution:
Do not install or uninstall the Network Image Express Card
from the scanner while the scanner is turned on; otherwise
damage may occur.
4. Initialize the Network Image Express Card. To initialize, turn
on the scanner while holding down the Reset button of the
Network Image Express Card for 10 seconds until the red
status light and green data light turn on.
Note:
Be sure to initialize the Network Image Express Card when you
insert or re-insert it in the scanner.
5. Turn off the scanner.
