Epson EU-T432, Техническое руководство

Страница: 34 / 126

Rev. A Operation Principles 2-23
EU-T432 Technical Manual
Confidential
(*1): Do not set SW 3 to ON in the following condition:
•
The partial cutter is used when the cut sheet presenter module is not used.
When backward paper feeding is enabled, the following process is executed.
•
After cutting the paper with a GS V command, backward paper feeding is executed (when the Black
mark detector is disabled).
•
The print starting position adjustment with a GS (F command can be set to the backward direction
relative to the cutting position. In this case, the maximum backward correction value is 14 mm {0.55"}
(112 step
×
0.125 mm {0.005"} per step).
(*2): Specific offline means the following states.
•
Error state except an automatic recovery error state
•
Platen open
•
Cut sheet presenter module or cover open
•
Paper empty
If this switch is turned on, the printer clears the receive buffer when the offline status shown above occurs. Then
the printer executes any real-time command (
DLE ENQ , DLE EOT ) if it is there, and discards all other data.
When the receive buffer is cleared, if this switch is turned on, three bytes of data, 37H, 24H, and 00H, are
transmitted.
×
: can be either setting
Table 2-13 Memory Switch 8
SW No. Function
ON (1) OFF (0)
Default setting
1 to 2
Print control mode
Refer to 2-14 OFF(0)
3 Backward paper
feeding Enabled Disabled OFF(0) (*1)
4 Autocutter
installation Not installed Installed OFF(0)
5 Specific offline
operation Discards receive
data Keeps receive data OFF(0) (*2)
6 Backward paper
feeding amount
88 steps 108 steps
OFF(0) 7 Test print when the
paper is loaded
Enabled
Disabled
8 Reserved

Fixed to OFF
Table 2-13 Print Control Mode Selection
Default for the print
control mode SW 1 SW 2
Non-divided energizing
mode
OFF OFF
Two-part energizing
mode
ON OFF
Four-part energizing
mode
×
ON