Epson EISA Desktop, Руководство пользователя

Страница: 59 / 184

Note
If you boot from a diskette, you see the Enter password
prompt. Enter your password as described under “Using a
Power-on Password” above.
You cannot change or delete a password when you boot from
the hard disk in network server mode. First insert a bootable
diskette in drive A and turn on the computer. Then change or
delete the password, as described in the previous section. If you
delete the password, the computer automatically turns off
network server mode.
Changing the Processor Speed
Your computer’s processor can operate at high speed, low
speed, and automatic speed, as well as other processor
simulation speeds. When it is at high speed, the TURBO speed
light is on.
You set the default (or power-on simulation) speed in the
System Configuration program, described in Chapter 2. If
necessary, you can temporarily change the processor speed
using keyboard commands or the ESPEED program.
High speed is the highest speed available on your processor
board and low speed simulates an 8 MHz processor speed.
Automatic speed switches from high to low speed whenever
the computer accesses a diskette. You can set simulation speeds
for various other processors using the System Configuration
program. See Chapter 2 for more information.
Certain application programs may have specific timing
requirements for diskette access and can run only at low speed.
See the manual for your program to determine if this is the case.
Using Your Computer
3-5