Epson AL-M7100 Series, Руководство пользователя

Страница: 62 / 98

The spool file on the driver is deleted while printing or
the data is abnormal. Press the
OK button to clear the
error.
Invalid N/W Module
There is no network program, or the network program
cannot be used with your printer. Contact a qualified
service representative.
Invalid PS3
There are errors in the ROM module. Turn off the
printer and contact your dealer.
Jam Paper Size Error
The paper jam occurred because the loaded paper size is
different from the specified paper size. Match the paper
size in the tray to the setting on the paper size setting dial
or control panel.
Maintenance Unit Needed Soon (AL-M8200/
AL-M8100 Series only)
This message indicates that the maintenance unit is near
the end of its service life. You can continue to print until
the
Replace Maintenance Unit
message appears. To
clear this warning message and continue printing, select
Clear All Warnings
from the control panel’s
Reset
Menu .
Manual Feed ssss
The manual feed mode is specified for the current print
job. Make sure the paper size indicated by ssss is loaded,
then press the
OK
button.
Memory Overflow
The printer has insufficient memory to execute the
current task. Press the
OK button on the control panel to
resume printing, or cancel the print job. To cancel the
print job, see
“Cancelling a Print Job” on page 55 .
Need Memory
The printer has insufficient memory to complete the
current print job.
To clear this warning message, select
Clear Warning
from the control panel’s
Reset Menu
.
To prevent this problem from recurring, reduce the
resolution of the image to be printed.
Non-Genuine Toner Cartridge
The installed toner cartridge is not a genuine Epson
toner cartridge. Installing a genuine toner cartridge is
recommended.
The printout and remaining service life of the toner
cartridge displayed on the control panel may be
different from those when using genuine Epson toner
cartridges. Epson shall not be liable for any damages or
problems arising from the use of consumable products
not manufactured or approved by Epson.
Press the OK button on the control panel to resume
printing.
Paper Out tttt sssss
There is no paper in the specified paper source (
tttt
).
Load paper of the size (
sssss
) into the paper source.
Please Wait
Printing cannot start because the previous job is being
processed. Try again after a few seconds.
Print Overrun
The required time to process the print data exceeded the
print engine speed because the current page is too
complex. Press the
OK button to resume printing, or
cancel the print job. To cancel the print job, see
“Cancelling a Print Job” on page 55 . If this message
appears again, select
On
as the
Page Protect
setting in
the control panel’s Setup Menu .
If you continue to receive this message when printing a
particular page, try simplifying the page by limiting the
number of graphics or reducing the number and size of
fonts.
RAM CHECK
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Reboot to apply settings
You selected
No
when
Do you want to reboot to
apply the settings?
was displayed. To clear this
warning message, select
Clear Warning
from the
control panel’s Reset Menu .
AL-M8200/AL-M8100/AL-M7100 Series User's Guide
Troubleshooting
62