Epson ActionLaser 1000, Руководство пользователя, Страница: 14 / 70

3. Gently slide the cartridge into the slot until it lochs in place.
4. Turn on the printer.
Once you insert the cartridge, you need to use SelecType™ to
select the EpsonScript emulation mode. See “Selecting the
EpsonScript Emulation Mode” later in this chapter.
To remove the cartridge, turn off the printer and remove the
cartridge by grasping it at the center and gently pulling it
straight out.
Installing
the EpsonScript
board
This section describes how to install the EpsonScript board if
you have an EPL-5600 or ActionLaser 1600 printer.
You install the EpsonScript board on the printer’s controller
board. To install the EpsonScript board, you need to first
remove the controller board as described in the "Options”
chapter of your printer manual.
Caution:
Do not attempt to remove the controller board unless the
printer is off and the power cord is unplugged. Removing the
controller board exposes the electrical components inside the
printer. These components may be very hot if the printer has
been used recently. Also, try not to touch the contacts on the
board because many
of
the components can be damaged by
static electricity.
Setting Up 1-3