background image

page | 4

www.snapav.com   Support 866.838.5052

EU COMPLIANCE INFORMATION

 

Eligible to bear the CE mark; Conforms to European Union Low Voltage 
Directive 2006/95/EC; European Union EMC Directive 2004/108/EC; 
European Union Restriction of Hazardous Substances Recast (RoHS2) 
Directive 2011/65/EC; European Union WEEE Directive 2002/96/EC; 
European Union Eco-Design Directive 2009/125/EC; European Union 
registration, Evaluation, Authorization and Restriction of Chemicals 
(REACH) Directive
2006/121/EC; European Union Radio and Telecommunications 
Terminal Equipment (R&TTE) Directive 1999/5/EC.
This product contains batteries that are covered under the 2006/66/
EC European Directive, which cannot be disposed of with normal 
household waste. Please follow local regulations.
You may obtain a free copy of the Declaration of Conformity by 
contacting your dealer, distributor or worldwide headquarters.

WEEE NOTICE
Note:

 This mark applies only to countries within the European Union 

(EU) and Norway.

This appliance is labeled in accordance with European 
Directive 2002/96/EC concerning waste of electrical and 
electronic equipment (WEEE). This label indicates that this 
product should not be disposed of with household waste. It 
should be deposited at an appropriate facility to enable 

recovery and recycling.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.  However, there is no 
guarantee that interference will not occur in a particular installation.  If 
this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one of 
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part 15 as a Class B 
Digital Device.

Caution:

 Changes or modifications not expressly approved by the 

manufacturer could void the user’s authority to operate this device.

Caution: 

To comply with the limits of the Class B digital device, 

pursuant to Part 15 of the FCC Rules, this device is to comply with 
Class B limits. All peripherals must be shielded and
grounded. Operation with non-certified peripherals or non-shielded 
cables my result in interference to radio or reception.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth 
for an uncontrolled environment. This equipment should be installed 
and operated with minimum distance 20cm between the radiator & 
your body.
Note: The country code selection is for non-US model only and is not 
available to all US model. Per FCC regulation, all WiFi product marketed 
in US must fixed to US operation channels only.
This Class B digital apparatus complies with Canadian ICES-003. CAN 
ICES-3 (B)/NMB-3(B) 

WIRELESS TRANSMITTER COMPLIANCE INFORMATION

The term “IC:” before the radio certification number only signifies that 
Industry Canada technical specifications were met.
This device complies with part 15 of the FCC Rules and the applicable 
Industry Canada license-exempt RSS standard(s). Operation is subject 
to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must 
accept any interference, including interference that may cause 
undesired operation of the device.
This equipment complies with FCC and IC radiation exposure limits 

set forth for an uncontrolled environment. This equipment should be 
installed and operated with minimum distance 20cm between the 
radiator and your body. This transmitter must not be co-located or 
operating in conjunction with any other antenna or transmitter.

PRÉCAUTIONS DE SÉCURITÉ IMPORTANTES A LIRE EN PREMIER !

1. 

Lisez ces instructions.

2. 

Conservez ces instructions.

3. 

Tenez compte de tous les avertissements.

4. 

Suivez toutes les instructions.

5. 

N’utilisez pas cet appareil près de l’eau.

6. 

Nettoyez uniquement avec un chiffon sec.

7. 

Ne bouchez aucune ouverture de ventilation. Installez 
conformément aux instructions du fabricant

8. 

Ne l’installez pas à proximité d’une source de chaleur telle 
que des radiateurs, des bouches de chaleur, des fourneaux 
ou d’autres appareils (y compris les amplificateurs) qui 
produisent de la chaleur.

9. 

Ne détournez pas l’objectif de sécurité de la fiche polarisée 
ou de mise à la terre. Une fiche polarisée a deux lames dont 
l’une est plus large que l’autre. Une fiche avec mise à la 
terre a deux lames et une troisième broche de mise à la 
terre. La lame large ou la troisième broche sont conçues 
pour votre sécurité. Si la fiche fournie ne s’insère pas 
correctement dans votre prise, consultez un électricien 
pour le remplacement de la prise obsolète.

10. 

Évitez de marcher sur le cordon secteur ou de le pincer, en 
particulier au niveau des fiches, des prises de courant et à 
son point de sortie de i 

11. 

Utilisez seulement des compléments/accessoires spécifiés 
par le constructeur.

12. 

Utilisez l’appareil seulement avec le chariot, pied, trépied, 
support ou table spécifié par le constructeur, ou vendu 
avec l’appareil. 

 Lors de l’utilisation d’un chariot, 

faites attention en déplaçant l’ensemble chariot/appareil 
afin d’éviter des blessures dues à un basculement.

13. 

Débranchez cet appareil pendant les orages ou s’il est 
inutilisé pendant de ‘algues périodes.

14. 

Confiez tous les travaux d’entretien à du personnel 
qualifié. Un entretien est nécessaire si l’appareil a été 
endommagé d’une façon quelconque, si le cordon ou la 
fiche d’alimentation sont endommagés, si du liquide a été 
renversé sur l’appareil ou si des objets sont tombés dedans, 
si l’appareil a été exposé à la pluie ou à l’humidité, s’il ne 
fonctionne pas normalement ou s’il est tombé.

15. 

L’appareil : ne doit pas être exposé à un égouttement ou à 
des projections et aucun objet rempli de liquide, tel qu’un 
vase, ne doit être placé sur . 

16. 

Pour débrancher complètement cet appareil du secteur, 
débranchez la fiche du cordon d’alimentation de la prise 
secteur.

17. 

La fiche secteur du cordon d’alimentation doit rester 
immédiatement accessible.

18. 

Les piles ne doivent pas être exposées à une chaleur 
excessive telle que le soleil, un feu ou un équivalent

AL’éclair avec un symbole fléché se trouvant dans un triangle 
équilatéral est destiné à alerter l’utilisateur de la présence d’un cc 
voltage dangereux » non isolé au sein du produit qui pourrait être d’une 
magnitude suffisante pour constituer un risque de décharge électrique 
sur une personne.
ÀkLe point d’exclamation se trouvant dans un triangle équilatéral 
destiné à alerter l’utilisateur de la présence de consignes de 
maintenance (entretien) et d’utilisation importantes dans la 
documentation accompagnant le produit. AVERTISSEMENT Pour 
réduire le risque d’incendie ou d’électrocution n’exposez pas cet 
appareil à la pluie ou à l’humidité

LEGAL NOTICE

Manufactured under license from Dolby Laboratories. Dolby and the 
double-D symbol are registered trademarks of Dolby Laboratories.

www.snapav.com   Support 866.838.5052

Содержание ES-SUB-ELE10-450

















Отзывы: