www.snapav.com Support 866.838.5052
page | 10
3. Set the controls to positions that will enable tuning for maximum performance.
VOLUME
set to 50%, or 12 o’clock
CROSSOVER
set to 175 Hz, or 12 o’clock – OR – set to ‘LFE’ if LFE input is used
PHASE
set to 0º
4. Play a movie scene or music track and set the system volume to an average
level. Listen to the bass level from the preferred listening position. Adjust the
‘VOLUME’ control as desired.
5. If deeper bass is desired, adjust the ‘CROSSOVER’ control toward the lower
frequencies. Experiment with different frequency settings until finding one
that sounds best.
NOTE:
When using the LFE input, set to LFE and make any crossover
adjustments in the preamplifier or receiver crossover settings.
6. Continue listening to music and movie sources using the settings chosen for
volume and crossover.
7. Experiment with the phase until finding the best setting. Depending on the
subwoofer’s placement, the bass may sound louder or deeper when the
phase has been optimized. In some cases, adjusting phase will make no
discernible difference.
SPECIFICATIONS
Continuous
Power Output
50 watts RMS at 8 ohms
100 watts RMS at 4 ohms
Input Sensitivity 140 mV for full output (L/LFE only driven), 100 watts,
with level control set to max
Frequency
Response
30-200Hz
Distortion
.10% THD+N 1W/2W 100 Hz
Auto On
Sensitivity
4 mV
External Trigger
Voltage
2.0 V - 20 V
Dimensions
6.68
"
W
1.75" H
7.11" D (front switch to rear chassis)
Weight
5.1 lbs
Certification
TUV Listed and tested under for US and Canada
