32
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
Press the power switch to the off position and
unplug the power cord.
To adjust the reed switch,
rst see assembly step 10
on page 10. Remove the Left Roller Arm (12) from
the Left Pedal Arm (44).
Next, see EXPLODED DRAWING A on page 37 and
EXPLODED DRAWING B on page 38. Remove the
M8 x 16mm Screw (72), the Axle Cover (53), and the
M8 x 25mm Washer (149) from the upper end of the
Left Roller Arm (12). Then, remove the Left Roller Arm
from the left Crank Arm (20). Set the Left Roller Arm
out of the way.
See EXPLODED DRAWING C on page 39. Using a
at screwdriver, pry the left Crank Arm Cover (71) off
the Left Front Shield (73).
Next, locate the Reed Switch (38). Turn the left Crank
Arm (20) until one of the Magnets (43) on the Pulley
(19) is aligned with the Reed Switch.
Loosen, but do not remove, the two indicated M4
x 16mm Screws (104). Slide the Reed Switch (38)
slightly closer to or away from the Magnet (43). Then,
retighten the Screws. Plug in the power cord and press
the power switch to the on position. Turn the left Crank
Arm (20) for a moment.
Repeat these actions until the console displays correct
feedback. Then, reattach the left crank arm cover and
the left roller arm.
STORAGE
If the elliptical will not be used for an extended period
of time, lay the power cord over the elliptical where it
will not be pinched or crushed, and cover the elliptical
to keep it free of dust. Store the elliptical indoors. Do
not store objects on the elliptical.
43
38
104
19
20
