Epever EG1200CU, Руководство пользователя

Страница: 21 / 32

shutdown in both modes. The setting procedure is
the same with the “output voltage”.
▼Set Interface —Series Rate
The SBR can be set in this page without
shutdown in both modes. The setting procedure is
the same with the “output voltage”. Press
↑ or ↓
button to change the value.
▼Set Interface —Restore Factory settings
Restore factory settings. The setting procedure is
the same with the “output voltage”. Press
↑ or ↓
button to change the value. The device will be
shut down when saving the setting value.
Table 5-2 The parameters in power mode
Item Code MIN Default MAX Unit Remark
Output voltage V.OUT 40.0 48.0 60.0 V
Output current C.OUT 0.0 20.5 20.5 A
Real-time output
power
P.OUT
W Fixed
Real-time input
voltage
V.IN
V Fixed
Real-time date DT Y.M.D
Real-time time TM H.M.S
Device address ID 0 2 180
Serial port baud
rate
SBR 9600 115200 115200 B
Press
↑ or ↓ button to
change the value.
Restore factory
settings
RSET NO YES
Press
↑ or ↓ button to
change the value.
Failure interface Fault codes in power mode
：
IOVP, ILVP, IOCP, OOVP,
OLVP, OSCP, DOTP, BOVP, ONLP, CFAL
The largest figure
represents the latest
failure.
The letters represent
the failure code.
SBR 1152
RSET YES
-17-