POWERED BY
2
SERIES
SERIES
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to
S04, S08, S16
DVR Pre-Installation
The DVR is highly advanced surveillance equipment that should be installed with care. Please take
into consideration the following precautionary steps before installation of the DVR.
1.
Keep all liquids away from the DVR.
2.
Install the DVR in a well-ventilated and dust-free area.
3.
Ensure environmental conditions meet factory specifications.
4.
Install a manufacturer recommended HDD.
DVR Installation
During the installation of the DVR:
1.
Use brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When installing cables, ensure that the bend radius of the cables are no less than five times
than its diameter.
4.
Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
5.
Ensure the DVR is grounded.
6.
Environmental temperature should be within the range of -10ºC ~ 55ºC, 14ºF ~ 131ºF.
7.
Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Before installing a hard disk drive (HDD), please make surethe power is disconnected from the
DVR. A factoryrecommended HDD should be used for this installation.
Tools Required: Screwdriver.
To install a HDD on your DVR:
1.
Remove the cover from theDVR by unfastening the screws on the back and
side.
2. Install the HDD in the HDD rack using the provided screws. Fasten the screws on the
bottom to fix the HDD.
3. Connect the HDD to the motherboard of the DVR with the included data cable, and
connect the power cable to the HDD.
