23
3.2.5 Depressurizing the machine
*
Completely retract the cylinders.
*
Deposit the compaction roller on the ground.
*
Completely retract the container hook.
*
Park the Jumbo Mobile Compactor on a level, straight surface and secure it with wedges.
3.2.6 Hazards caused by misuse
*
Do not drive the Jumbo Mobile Compactor up inclines of over 11% (6.5°) or 2% for machines with
a container moving unit. Epax Systems cannot guarantee the Jumbo Mobile Compactor’s stability
for inclines of over 11 respectively 2%.
*
Only operate the compaction roller after the Jumbo Mobile Compactor has been moved properly to
a position in front of a container.
*
Epax Systems cannot guarantee stability for weights over 10t. Moreover, material damage may
occur.
*
Ensure that the compaction roller does not pick up non-compactable materials such as steel beams,
rocks, etc. These would cause significant damage to the Jumbo Mobile Compactor and the container.
*
Avoid contact with curbs and stone edges. This may damage the machine and lead to a loss of
stability.
*
A wheel motor leak is caused by improper operation of the
Jumbo Mobile Compactor.
For instance by improper use of the EMERGENCY STOP button during operation or by pushing the
slide switch to roller mode during operation.
An abrupt stop caused by improper operation can destroy the housing seal in the hydraulic drive
motors of the MOBIL-JUMBO.
Only the drive hydraulics are to be used to decelerate the driving movement.
3.2.7 Maintenance and service work
*
Have the specified maintenance and inspection work carried out within the specified intervals (see
chapter 11 "Maintenance and care").
*
Only allow expert personnel with the required knowledge to carry out maintenance and repair work.
During work, secure the machine against being switched on.
*
Prior to maintenance and repair work on the machine, switch off the engine and allow it to cool
down.
*
If necessary, secure a large area around the repair work area.
*
If necessary, use a certified ladder or work platform sufficient for the respective purpose. It is the
owner/user's responsibility to provide this equipment.
*
When replacing large assembly groups, carefully fasten them to lifting gear and secure them. Only
use suitable lifting equipment in perfect technical condition with sufficient load-bearing capacity.
Never stay or work beneath suspended loads.
*
Replace hydraulic hose lines at least every 6 years, even if no safety-relevant faults can be detected.
3. 06
Содержание ROPAX RPM 7700 VII
Страница 63: ...63 11 01 Figure standard design actual design may differ...
Страница 76: ......
