17
17
17
3.2 Lock-Out and Tag-Out Instructions
FOREWORD: Before entering any part of the compactor, be sure that
all sources of energy have been shut off, all potential hazards have
been eliminated, and the compactor is locked-out and tagged-out in
accordance with OSHA and ANSI requirements.
The specific lock-out and tag-out instructions may vary from company to company (i.e. multiple locks may
be required, or other machinery may need to be locked out and tagged-out). The following instructions are
provided as minimum guidelines.
INSTRUCTIONS
1. If the ROPAX™ Jumbo Rolling Compactor is operable, raise the drum to its maximum elevation.
2. Remove the container from the compactor.
3. Open the front door of the compactor.
4. Turn the “KEY” switch to the “OFF” position and remove the key and keep it in your possession.
5. Turn the fused disconnect switch “OFF” and padlock it with a keyed padlock. Remove the key and take
it with you.
6. In addition to the padlocking, place an appropriate, highly visible, warning tag on the disconnect lever.
The tag should provide a warning such as: “ Danger: do not operate equipment. Person working on
equipment. Warning: Do not energize without the permission of (Name of individual)”.
7. After locking and tagging the ROPAX™ Jumbo Rolling Compactor, try to start and operate the compactor
(as outlined in the Operation Manual) to make sure the lock-out and tag-out is effective. You may begin
to service the compactor after you have determined that the lock-out and tag-out is effective.
ELECTRICAL:
the panel box contains high voltage components. Only authorized service personnel should
be allowed inside the box. Authorized service personnel should be allowed inside the box only after the
compactor has been locked-out and tagged-out.
HYDRAULIC:
Stored hydraulic energy must be released from the compactor hydraulic circuit for complete
lock-out and tag-out. Make sure that this energy has been released by manually depressing the solenoid
valve pin located in the center of each coil of the directional control valve on the power unit.
Содержание ROPAX RPM 7700 VII
Страница 63: ...63 11 01 Figure standard design actual design may differ...
Страница 76: ......
