EPAK Basic Line Series, Руководство пользователя

Страница: 20 / 34

6. Miscellaneous
6.1. Adjustments of LNB- type
To change the LNB- type please proceed as follows:
1. Go to the Setup menu, press

repeatedly until the display shows
Setup
(flashing), then press

.
Enter password, see chapter 3.4. If the password is correct you are in the setup menu,
Tracking
is
shown on
the display.
2. Press

repeatedly until
LNB Type
appears. Press

to confirm.
3.
The display will show the standard setting
lin 0
which is valid for Europe. By pressing the

key
you can change the LNB settings. Press

to select. The display will return to
LNB Type
.
Just for River/ Basic Line antennas:
!!Please consider that the
LNB type
is preset to
lin 0
. The LNB mounting plate allows a
modification of the skew, which can be adjusted to the location.
!! Important : In addition to the changes of the control unit the skew (polarization angle) at the LNB
and the matrix has to be changed accordingly (attend to the addendum „ How to adjust
the polarisation angle (Skew)“).
The integrated GPS module is able to calculate the right skew and elevation angle of the desired
satellite (only in Channel-Tracking mode! see chapter 5.1) and it is competent to inform about a
difference (within the menu
New Sat
) between the adjusted and calculated settings .
Reception of circular polarized satellites will require a circular LNB type.
To change this, go to the
SETUP
menu till the display shows
LNB Type
Press
a
to change then press
q
until the display shows
Circular
and press
a
to select.
4. Press

repeatedly until
quit
appears. Press

to confirm,
Setup
appears (flashing)
.
You are now back in the main menu and can switch to other satellites by pressing the

key or make
adjustments in the Setup menu by pressing the

key
.
6.2. Special functions via the Standby mode
The following information can be obtained via the Standby mode: software version of antenna unit and
control unit, serial number and operating hours counter.
Please proceed as follows:
1.
Turn on the control unit. The display shows
Init
, meaning initialization is started. Wait for the
initialization to be completed, and then press the

key to enter the Standby mode.
2. To obtain the special functions, press and hold the

key
while switching between the following
functions with the

key:
• serial number.
• operating hours counter.
• software version of the antenna unit:
VA X-XX
• software version of the control unit: VC X-XX
3. After releasing the

key, the display returns to
Standby
.
English Page 20 / 34