EP Equipment EPT18-EHJ, Руководство по эксплуатации

Страница: 37 / 59

REV. 08/2019
7
E
Hoisting the Truck ( See dentification points and data plates)
This section explains the attachment of lifting equipment to the truck for the purpose of
hoisting. Many methods of rigging to a crane or hoist are possible. Explanation of such
methods as well as operation of lifting equipment is outside the scope of this manual. Both
the attachment of lifting equipment to the truck and the hoisting operation itself must be
performed by personnel experienced in hoisting.
Lifting equipment of insufficient capacity can fail and cause severe injury or death.
Ensure that all lifting slings, hardware, or other equipment has sufficient capacity to carry
the weight of the truck. Refer to the truck data plate for truck weight. If a battery is installed,
its weight must be added to the truck weight listed on the data plate.
Switch the truck off and press the emergency stop button.
Attach lifting equipment to the holes in each side of the chassis.
Attach lifting equipment to the fork tips to keep the truck approximately horizontal as it is lif-
ted.
Handle and handle lever installation
Individual trucks are assembled and ready to use.
Semi-electric pallet trucks purchased in crate require
some assembly.
Unscrew the four fastening M5×20 screws (1) on
the back of Control Handle (3),and remove the
Upper Cover (2).
Pull wire harness out through the hole of Control
handle (3).
Connect the connectors of Control handle to the
wire harness.
Fix the Upper Cover (2) to Control handle (3),and
tighten the four screws (1). Please take care not to
crush and damage the wire harness.
i
NOTE
EPT20-15ET2 / EPT20-ET/EPT20-15ET /
EPT20-18EA
WARNING
1.5