03
04
①
Power off (emergency stop button)
Ins
trum
ent
Mast
Emergency stop switch
Handle
Battery
Fork arms
Load-bearing wheel
②
Key switch
Safe operating rules
12. Negotiating of slopes
Negotiating of slopes is permitted only when they are recognized lanes, when they are clean and non-
slipping, and when the technical specification of the truck permits safe driving on such slopes or inclines.
Loads must always be carried facing uphill. U-turns, cutting obliquely over slopes and parking of the truck
on slopes is not permitted. Slopes must only be negotiated at slow speed, with the driver ready to brake at
any moment.
13. Ground load
Carefully check the truck during its operation to see if the weight of truck body and loads or wheel pressure
exceeds the ground load capacity.
14. Stable operation
Travel of stacker shall be stable, avoiding sudden brake, sharp turns and sudden start. The fork arms should
be lowered to their lowest position during travel.
15. Loaded and unladen
When the loaded stacker travels, the goods must face uphill. When unladen stacker travels, the fork arms
can face downhill.
16. Parking
The truck must be parked on a level and hard ground, engaged with a parking brake. The fork arms must
be lowered to their lowest position. Always turn the key switch to the “OFF” position and remove the key
when leaving the truck.
If the truck is left unused for a prolonged period, ensure that its battery is fully charged, then the battery
connecting wire should be disconnected.
17. Repair
Operation guide
1
.
Component
2
.
Switch
Press the red button (emergency stop button) to cut off the power supply and turn off all electrical
control functions. Turn off the power when the truck is not in operation. Operating the key switch can
not disconnect all electrical control functions. If the truck does not function properly, please stop
using it immediately.
When you turn this switch clockwise, it will switch on the power. When you turn this switch
counterclockwise, it will switch off the power. Before leaving the stacker, fully lowered its forks and
take out the key switch.
Key s
witch
Emerge
ncy
stop
switch
T12 Series Electric Stackers
The operator without professional training and special authorization, must not repair or change installation
position of any part, especially the switches and safety devices of the truck.
All original parts have been checked by the quality inspection departments. To ensure the safety and
reliability of the truck, only the manufacturer's parts can be used. Replaced parts, such as oil and fuel
must be disposed of in accordance with the appropriate environmental protection rules.
