EOS SBM-FL150, Инструкция по установке и эксплуатации

Страница: 21 / 43

21
EN
• Hook the module to the screw that protrudes 3 mm in the upper attachment hole.
• Place the supplied rubber bushings into the openings of the lower part of the housing (either
from below or behind) and then feed the power cable through these openings.
• Screw the lower part of the housing to the cabin wall via the two lower boreholes (Fig. 2).
1.
130
180
3
1.
Assembly
• Remove the upper part of the housing To do this, completely unscrew the 3 to 4 screws and pull
off the upper part. (Fig. 1).
• The boreholes for the supplied wood screws 4 x 25 mm are attached in the dimensions as shown
in Fig. 2.
• Turn one of the wood screws into the upper middle hole. The load unit is attached to this screw.
To this end, allow the screw to protrude approx. 3 mm (detail in Fig. 2).
Fig. 1.1
Fig. 2.1
The module may only be mounted outside the cabin. Possible assembly sites are the outer wall
of the cabin or the equipment room. It can also be mounted to the ceiling of the cabin, if there is
adequate ventilation. If empty ducts are already installed for the electrical cables, the position of
the module depends on these. Please follow the instructions for installation:
1.
2.
210
180
3
150 W
75 W
Fig. 1.2
Fig. 2.2