EOS Invisio Midi, Инструкция по сборке и эксплуатации

Страница: 35 / 57

35 EN
11. Commissioning
!
Risk of fire! Always make sure before
switching the sauna heater that no objects
were forgotten on the safety grill.
Switch on the control unit.
Select the appropriate operation mode (set-
tings).
By the first heat-up an unpleasant odour of
burned lubricants may appear. This is normal
and will only take place by the first heating.
Ventilate the sauna properly. By later use no such
unpleasant odours shall occur
12. Troubleshooting
Problem: Heater does not heat or doesn’t heat
properly.
Reason: Fuses blown, control unit fault, one or
several heating elements are faulty.
Help: Check fuses, check control unit and con-
nections, check and if necessary replace faulty
elements (only through a qualified specialist).
Problem: No evaporation effect after filling
water into the water-splash funnel
Reason: Connection tube lose, blocked or has
a sharp bend
Help: Check the water supply silicone tube from
the funnel to the heater.
13. Maintenance
How to replace heating elements
Preparation
1. Disconnect the heater from power.
2. Gain access to heater.
3. Remove metal elbow (water tube) and
take off the deflector cover (1) (4 screws).
4. Remove the cover of the terminal box
(6) (4 screws).
5. Lift up and remove the gutter. Take out
the rock store (2).
6. Remove the sauna rocks.
7. Pull out the support frame for heating
elments (3) (2 screws).
Remove the old heating element
8. Pull off the cable contacts from the heat-
ing element.
9. Undo the fixation nut of the heating
element.
10. Pull the heating element inwards and
take it out.
Installing heating elements
11. Insert a new heating element into posi-
tion in reverse order.
12. Fasten the heating element with the
fixation nut.
Final steps
13. Insert the support frame (3) back into
position
14. Insert the rock store (2) back into po-
sition
15. Fill the sauna rocks into the store.
16. Mount the gutter to the rock store (2)
(2 screws).
17. Restore the electrical connections to the
heating elements.
18. Install the terminal box cover (6) (4
screws)
19. Mount the deflector cover (1) back
on the heater (4 screws). Insert the metal
elbow with water feed tube back into the
side opening.
20. Move the heater back into the original
position.
21. Restore the power supply to heater.
Moving the sauna heater
!
Remove the sauna stones before moving
the heater. Do not pull or push the heater over
floor, this may cause scratches of the floor or
may damage the feet. Lift the heater slightly and
reposition it as required.