EOS Invisio Midi, Инструкция по сборке и эксплуатации

Страница: 34 / 57

34 EN
Fig. 8
Terminal box
cover panel
safety grill
partition wall
Fig. 7
7. Temperature sensor installation
Contradictory to the advice concerning the
installation of the sensor given in the sauna
control unit manual, the temperature sensor
shall be mounted centered to the heater on the
side wall 10 cm under the safety grill - as shown
on the page 9, fig. 1.
Connect the sensor as per installation manual of
the sauna control unit.
8. Electrical connection
Loosen 4 screws (4,2x9,5) to remove the cover
panel of the terminal box on the heater side.
Make electrical connections as per wiring dia-
gram (pages 7 - 8). The wiring diagram is also
attached on the inner side of the cover panel.
Draw the cable through the opening in the bot-
tom of the terminal box and close the terminal
box compartment.
9. Partition wall and safety grill
Install the partition wall (screen) so that the safe-
ty gaps as given on Fig. 1, page 8, are observed.
Make sure that the heater’s hot air exit opening
is lined up properly with the screen wall gap.
The partition wall does not belong to the deliv-
ery scope of the sauna heater.
Ensure that the partition wall is mounted tightly.
Mount the safety grill along the top edge of the
partition wall with two fastening screws(5x16).
!
The safety grill prevents that an
object may be accidentally dropped on
the heater. Do not use the heater without
safety grill! Fire risk!
10. Mount the warning shield
Mount the warning shield with 4 screws (2,9x9,5)
to the sauna wall above the screen wall. The
standard shield is supplied in German. A local
language version “Do not place any objects on
the grill. Risk of fire!” has to be provided on site.